Stay warm & cozy inside when it’s chilly or bone-chilling outside.
Select a participating contractor that will come to your home with information about furnace equipment that qualifies for rebates.
After you select a new model, your contractor will:
Your rebate check will arrive by mail in six to eight weeks .
Newer furnaces operate up to 50% more efficiently than older units. You’ll save money and energy after replacing your unit.
If you are a DTE residential natural gas customer, you are eligible for furnace and thermostat replacement rebates. If you are a DTE residential electric customer, you are eligible to replace your air source or ground source heat pump or ductless mini-split. Electric rebates can be found in the table on this page. New construction and first-time installation are not covered in the rebate program.
For more information, please call us toll free, (866) 796-0512 or email us.
| Natural Gas Heating Equipment† | Rebates |
|---|---|
|
Furnace 97% AFUE 96% AFUE 95% AFUE |
$500 $200 $100 |
|
Tune-Up with combustion analysis |
$75 |
|
AFUE (Annual Fuel Utilization Efficiency) is a measure of how efficiently your furnace can utilize its fuel. The higher the AFUE percentage, the better. (Minimum efficiency, 78%; Mid-Efficiency, 80%-85%; High-Efficiency, 90%-97%) † Premise eligibility is limited to single family homes. Single family homes are defined as 2 or less connected units. Each unit must be individually metered for natural gas and electric and each unit must have its own heating, cooling and water heating equipment. |
|
For more information, please call us toll free, (866) 796-0512 or email us.
How much could you save with a high-efficiency furnace?
As of 01/01/2023
0%
0%
Rebates funds are available on a first-come, first-served basis and customers are encouraged to apply early, as program funds are limited.
A participating contractor will use advanced diagnostic tools to check and adjust your furnace for efficiency, safety and reliability - optimizing and extending the life of your equipment.
Your contractor will:
You qualify for a Tune Up with Combustion Analysis rebate if you are a DTE residential, natural gas customer and natural gas is the primary heat source for your home. Your furnace must have a minimum 40,000 BTU capacity.
To receive a rebate for your tune-up you must: use a participating contractor who offers diagnostic tune-up services and have a full diagnostic report captured as part of your rebate paperwork. A standard tune-up by a participating or non-participating contractor without a diagnostic tune-up report will not be eligible for a rebate.
Premise eligibility is limited to single family homes. Single family homes are defined as 2 or less connected units. Each unit must be individually metered for natural gas and electric and each unit must have its own heating, cooling and water heating equipment.There is a limit of one rebate per gas-fired furnace Tune-Up with Combustion Analysis every two years.
A participating contractor must perform the Tune-Up with Combustion Analysis and then submit your rebate application within 20 days of service.
For more information, please call us toll free, (866) 796-0512 or email us.
For more information, please call us toll free, (866) 796-0512 or email us.
As of 01/01/2023
0%
0%
Rebates funds are available on a first-come, first-served basis and customers are encouraged to apply early, as program funds are limited.
