Furnaces & Boilers

Stay warm & cozy inside when it’s chilly or bone-chilling outside.

Upgrade to a high efficiency model and get rebates up to $900.

How it works

A participating contractor will come to your home with information about furnace or boiler equipment that qualifies for rebates.

After you select a new model, your contractor will:

  • Properly size the equipment for maximum efficiency.
  • Remove the old model and install your new unit.
  • Fill out and submit a rebate form for you online.

Your rebate check will arrive by mail in six to eight weeks .

Newer furnaces and boilers operate up to 50% more efficiently than older units. You’ll save money and energy after replacing your unit.

If you are a DTE residential natural gas customer, you are eligible for furnace, boiler and thermostat replacement rebates. If you are a DTE residential electric customer, you are eligible to replace your air, ground or ductless heat pump.

New construction and first-time installation are not covered in the rebate program.

For more information, please call us toll free, 866.796.0512 or email us.

Natural Gas Heating Equipment Rebates

Furnace

97% AFUE - best

96% AFUE - better

95% AFUE - good

$400

$250

$200

Boiler

95% AFUE - best

92% AFUE - better

90% AFUE - good

$900

$600

$200

Tune-Up

with combustion analysis

$50

AFUE (Annual Fuel Utilization Efficiency) is a measure of how efficiently your furnace can utilize its fuel. The higher the AFUE percentage, the better. (Minimum efficiency, 78%; Mid-Efficiency, 80%-85%; High-Efficiency, 90%-97%)

Search the DTE directory for participating contractors.

Find a Contractor

For more information, please call us toll free, 866.796.0512 or email us.

Furnace Savings Calculator

How much could you save with a high-efficiency furnace?

Limited Rebates Available

As of 5/18/2020

Electric Customers

28%

Natural Gas Customers

28%

Rebates funds are available on a first-come, first-served basis and customers are encouraged to apply early, as program funds are limited.

Tune-Up Your Furnace or Boiler and receive a $50 rebate.

How it works

A participating contractor will use advanced diagnostic tools to check and adjust your furnace or boiler for efficiency, safety and reliability - optimizing and extending the life of your equipment.

Your contractor will:

  • Conduct a tune-up with combustion analysis, ensuring optimal performance from your equipment and lowering your energy costs.
  • Fill out and submit a rebate form for you online.
  • Your rebate check will arrive by mail in six to eight weeks.

You qualify for a Tune Up with Combustion Analysis rebate if you are a DTE residential, natural gas customer and natural gas is the primary heat source for your home. Your furnace or boiler must have a minimum 40,000 BTU capacity.

Rebates are available for up to two units at single-family homes, condos or townhomes. There is a limit of one rebate per gas-fired furnace or boiler Tune-Up with Combustion Analysis every two years.

A participating contractor must perform the Tune-Up with Combustion Analysis and then submit your rebate application within 20 days of service.

For more information, please call us toll free, 866.796.0512 or email us.

Search the DTE directory for participating contractors.

Find a Contractor

For more information, please call us toll free, 866.796.0512 or email us.

Limited Rebates Available

As of 5/18/2020

Electric Customers

28%

Natural Gas Customers

28%

Rebates funds are available on a first-come, first-served basis and customers are encouraged to apply early, as program funds are limited.